Fspf Configuration Example; Network Requirements; Configuration Procedure - HP 6125XLG Configuration Manual

0xfffffa/24
0xfffffc/24
0xfffffd/24
# Display the FC routing table in VSAN 1 on Switch C.
[SwitchC] display fc routing-table vsan 1
Routing Table: VSAN 1
Destinations : 6
Destination/mask
0x010000/8
0x020000/8
0xfffc03/24
0xfffffa/24
0xfffffc/24
0xfffffd/24
# On Switch A, use the fcping command to ping Switch C and check whether Switch C is reachable.
[SwitchA] fcping fcid fffc03 vsan 1
FCPING fcid 0xfffc03: 128 data bytes, press CTRL_C to break
Reply from 0xfffc03: bytes = 128 time = 23 ms
Reply from 0xfffc03: bytes = 128 time = 9 ms
Reply from 0xfffc03: bytes = 128 time = 19 ms
Reply from 0xfffc03: bytes = 128 time = 14 ms
Reply from 0xfffc03: bytes = 128 time = 25 ms
--- 0xfffc03 fcping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 9/18/25 ms
The output shows that Switch A can reach Switch C.

FSPF configuration example

Network requirements

As shown in
Figure 18 Network diagram

Configuration procedure

1. Configure Switch A:
DIRECT
DIRECT
DIRECT
Routes : 6
Protocol
STATIC
STATIC
DIRECT
DIRECT
DIRECT
DIRECT
Figure 18, configure FSPF to enable the two FCF switches to communicate with each other.
0 0
0 0
0 0
Preference Cost
10 0
10 0
0 0
0 0
0 0
0 0
67
InLoop0
InLoop0
InLoop0
Interface
Vfc2
Vfc2
InLoop0
InLoop0
InLoop0
InLoop0