Configuring The Fspf Cost For An Interface; Configuring The Hello Interval For An Interface; Configuring The Dead Interval For An Interface - HP 6125XLG Configuration Manual

Step
1. Enter system view.
2. Enter VSAN view.
3. Configure the minimum
LSR refresh interval.

Configuring the FSPF cost for an interface

Each link has a different cost. The route selection algorithm uses this value to determine the best route. The
smaller the interface FSPF cost, the smaller the link cost.
To configure the interface FSPF cost:
Step
1. Enter system view.
2. Enter VFC interface view.
3. Configure the FSPF cost for
the VFC interface in a
specified VSAN.

Configuring the hello interval for an interface

The hello interval specifies the time between the hello packets sent periodically by the switch to discover
and maintain neighbor relationships.
NOTE:
The configured hello interval must be smaller than the dead interval and must be the same at the two ends
of the link.
To configure the interface hello interval:
Step
1. Enter system view.
2. Enter VFC interface view.
3. Configure the hello interval for
the VFC interface in a specified
VSAN.

Configuring the dead interval for an interface

After two switches establish a neighbor relationship, they send hello packets at the hello interval to each
other to maintain the neighbor relationship. The dead interval specifies the interval during which at least
one hello packet must be received from a neighbor before the neighbor is considered to be nonexistent
and is removed.
Command
system-view
vsan vsan-id
fspf min-ls-interval value
Command
system-view
interface vfc
interface-number
fspf cost value vsan
vsan-id
Command
system-view
interface vfc interface-number
fspf hello-interval value vsan
vsan-id
60
Remarks
N/A
N/A
The default setting is 5 seconds.
Remarks
N/A
N/A
The default setting is 100.
Remarks
N/A
N/A
The default setting is 20 seconds.