Download Print this page

HP 6125XLG Configuration Manual: Configuring Fspf; Configuration Procedure; Fspf Configuration Task List; Enabling Fspf

R2306-hp 6125xlg blade switch fcoe configuration guide.
Hide thumbs

Advertisement

Configuration procedure
To configure a static FC route:
Step
1.
Enter system view.
2.
Enter VSAN view.
3.
Configure a static FC
route.

Configuring FSPF

FSPF is enabled by default. Generally, you do not need to make special configurations.
You can change FSPF parameters on a per-VSAN or per-interface basis as needed.
FSPF configuration task list
Tasks at a glance
Change FSPF parameters for a VSAN in VSAN view:
(Required.)
(Optional.)
(Optional.)
(Optional.)
(Optional.) Change FSPF parameters for an interface in E_Port interface view:
Configuring the FSPF cost for an interface
Configuring the hello interval for an interface
Configuring the dead interval for an interface
Configuring the LSR retransmission interval for interfaces
Disabling FSPF for an interface
(Optional.) Configuring FSPF GR in system view:
Configuring the GR restarter
Configuring the GR helper
Enabling FSPF
FSPF-related functions can work in a VSAN only after you enable FSPF for the VSAN.
To enable FSPF:
Step
1.
Enter system view.
Command
system-view
vsan vsan-id
fc route-static fcid { mask | mask-length }
interface-type interface-number [ cost
cost-value ]
Enabling FSPF
Configuring the shortest SPF calculation interval
Configuring the minimum LSR receiving interval
Configuring the minimum LSR refresh interval
Command
system-view
Remarks
N/A
58
Remarks
N/A
N/A
By default, no static FC route exists.

Advertisement

   Related Manuals for HP 6125XLG

Comments to this Manuals

Symbols: 0
Latest comments: