Vfc Interfaces And Fip Configuration Example; Network Requirements; Configuration Procedure - HP 6125XLG Configuration Manual

Task
Display VFC interface information.
Display FCoE global configuration.
Clear the statistics for VFC interfaces.

VFC interfaces and FIP configuration example

Network requirements

As shown in
the number of devices, network adapters, and cables.
Figure 12 Network diagram
If the FCF switch is connected to a server or storage device with a converged network adapter (CNA),
you must also configure DCBX on the connecting Ethernet interface. For information about configuring
DCBX, see Layer 2—LAN Switching Configuration Guide.

Configuration procedure

This section describes the configurations for VFC interfaces and FIP on the FCF switch.
1. Configure Switch A:
# Configure Switch A to operate in advanced mode, save the configuration, and reboot Switch A.
(Skip this step if the switch is operating in advanced mode.)
<SwitchA> system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Configure Switch A to operate in FCF mode and create VSAN 10.
<SwitchA> system-view
Figure 12, use the FCoE solution in a data center combining a LAN and a SAN to reduce
Command
display interface [ vfc [ interface-number ] ] [ brief
[ description ] ]
display fcoe
reset counters interface [ vfc [ number ] ]
17