Displaying The Source Ip Interface Information - HP ProCurve 6120G/XG Configuration Manual

Configuring IP Addressing
Configuring a Single Source IP Address

Displaying the Source IP Interface Information

There are several show commands that can be used to display information
about the source IP interface status.
Syntax
ProCurve(config)# show ip source-interface status
Source-IP Status Information
Protocol | Admin Selection Policy
-------- + ----------------------- -----------------------
Tacacs | Configured IP Interface Configured IP Interface
Radius | Configured IP Address
Syslog | Configured IP Interface Outgoing Interface
Telnet | Outgoing Interface
Tftp | Outgoing Interface
Sntp | Outgoing Interface
Figure 8-14. Example of the Data Displayed for Source IP Interface Status
When executing the show ip source-interface command without parameters,
the configured IP interfaces (VLANs) and IP addresses are displayed for each
protocol.
8-24
: show ip source-interface status [radius | sntp | tacacs | telnet | tftp | syslog]
Displays the operational status information for the source IP
address selection policy. Both the administratively-assigned
source IP selection policy and the operational source IP
selection policy are displayed.
When no parameters are specified, policy information for all
protocols is displayed.
Oper Selection Policy
Configured IP Address
Outgoing Interface
Outgoing Interface
Outgoing Interface