Setting The Default Flash - HP ProCurve 6120G/XG Configuration Manual

Table 6-2.
Actions
Save all
configuration
changes since the
last boot or reload
Perform all system
self-tests
Choice of primary or
secondary flash
image
Perform a scheduled
reboot

Setting the Default Flash

You can specify the default flash to boot from on the next boot by entering the
boot set-default flash command.
Syntax: boot set-default flash [primary |secondary]
ProCurve(config)# boot set-default flash secondary
ProCurve(config)# show flash
Image Size(Bytes)
----- ----------
Primary Image : 7173079
Secondary Image : 7173079
Boot Rom Version: Z.14.03
Default Boot : Secondary
ProCurve(config)# boot
This management module will now reboot from secondary and will become
the standby module! You will need to use the other management module's
console interface. Do you want to continue [y/n]?
Figure 6-13.Example of boot set-default Command with Default Flash Set to Secondary (with a
Redundant Management Module Present)
Using Primary and Secondary Flash Image Options
Comparing the Boot and Reload Commands
Included In Included In Reload
Boot?
Optional, Optional with reload
with prompt <cr>, when prompt
displays.
Not saved with
at/after
No prompt is displayed.
Yes No
Yes No—Uses the current
flash image.
No Yes
Upon booting, set the default flash for the next boot to primary
or secondary.
Date Version
-------- -------
07/27/09 Z.14.04
07/27/09 Z.14.04
Switch Memory and Configuration
Note
Config changes saved to
the startup-config file if
"y" is selected (
command).
reload
commands;
The reload
provides a faster system
reboot.
reload
Use the
with after/at parameters
(see page 6-24 for details).
reload
command
command
6-21