Related
Documentation
Replacing a T4000 CIP
Removing a T4000 CIP
Copyright © 2013, Juniper Networks, Inc.
Figure 99: Installing an LCC-CB
T4000 Control Board Description on page 36
T4000 LCC-CB on page 37
T4000 LCC-CB Control Board LEDs on page 37
Replacing T4000 Host Subsystem Components on page 248
The CIP is located to the left side of the FPC card cage. It houses the Routing Engine
interface ports, which accept connections to external management and alarm-reporting
devices.
The CIP is hot-pluggable. It weighs approximately 8 lb (3.6 kg). When the CIP is removed,
you cannot control or communicate with the router using an external device.
Removing a T4000 CIP on page 231
1.
2.
Installing a T4000 CIP on page 233
To remove the CIP (see
Figure 100 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the site ESD points on the chassis.
Disconnect any external devices connected to the CIP.
2.
Chapter 19: Replacing T4000 Router Hardware Components
232):
231