Installing A T4000 Cip - Juniper T4000 Hardware Manual

Installing a T4000 CIP

Copyright © 2013, Juniper Networks, Inc.
To install the CIP (see Figure 101 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Grasp the CIP handle with one hand and hold the bottom edge of the CIP with the
2.
other hand to support its weight.
NOTE: The components on the CIP are on the left side of the board, unlike
the components of an FPC, which are on the right side. Verify that the
components are on the left before inserting the CIP.
Insert the CIP into the leftmost slot of the FPC card cage, carefully aligning the top
3.
and bottom of the CIP with the guides in the card cage.
Carefully push the CIP straight into the chassis until it contacts the midplane.
4.
Tighten the screws at the top and bottom of the CIP faceplate.
5.
Reattach any external devices connected to the CIP.
6.
CAUTION: Be sure to slide the CIP straight within the slot to avoid
damaging the connector pins on the front of the midplane.
To verify that the CIP is installed correctly, plug an Ethernet cable into the Ethernet
7.
port on the CIP. If the host module is operational, the
Ethernet activity. If you can run the CLI, the CIP is installed correctly.
Chapter 19: Replacing T4000 Router Hardware Components
234):
ACTIVE LED blinks to indicate
233