Installing A T4000 Fpc; Figure 110: Removing An Fpc - Juniper T4000 Hardware Manual

Installing a T4000 FPC

Copyright © 2013, Juniper Networks, Inc.

Figure 110: Removing an FPC

T-1 60 0 FP C4
CAUTION: The FPC power connector is located in the corner where the bottom
and the connector edges meet. If a power connector prong becomes bent, it
no longer aligns with the female connector on the midplane, and the FPC no
longer functions.
To install an FPC (see Figure 111 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Place the FPC on an antistatic mat.
2.
Take each PIC to be installed in the replacement FPC out of its electrostatic bag and
3.
identify the slot on the FPC where it will be connected.
Chapter 19: Replacing T4000 Router Hardware Components
247):
245