Juniper T4000 Hardware Manual page 40

T4000 Router Hardware Guide
16
measures 37.45 in. (95.1 cm) high, 31 in. (78.7 cm) deep, and 17.43 in. (44.3 cm) wide. The
chassis can be installed into many types of racks or cabinets.
The chassis includes the following features (see
Figure 7 on page 18):
Front-mounting flanges for mounting in a four-post rack or cabinet or front-mounting
in an open-frame rack.
Center-mounting metal brackets for center-mounting in an open-frame rack.
Handles on each side to facilitate positioning the router in the rack. Do not use the
handles to lift the router.
Two electrostatic discharge (ESD) points (banana plug receptacles), one front and
one rear.
CAUTION: Before removing or installing components of a router, attach
an ESD strap to an ESD point, and place the other end of the strap around
your bare wrist. Failure to use an ESD strap could result in damage to the
router.
WARNING: The router must be connected to earth ground during normal
operation.
Figure 6 on page 17 and
Copyright © 2013, Juniper Networks, Inc.