Figure 111: Installing An Fpc - Juniper T4000 Hardware Manual
Hide thumbs
Also See for T4000:
- Datasheet (4 pages) ,
- Hardware manual (468 pages) ,
- Quick start manual (40 pages)
Table of Contents
Advertisement
Copyright © 2013, Juniper Networks, Inc.
Figure 111: Installing an FPC
Gently rest the bottom edge of the FPC on the bottom edge of the slot opening, making
12.
contact a short distance forward of the power connector.
CAUTION:
Take care not to bend or otherwise damage the power
connector prongs.
Slowly slide the FPC into the slot until you feel resistance.
13.
Align the ejector handles on the FPC faceplate in a position close to horizontal.
14.
Simultaneously turn both ejector handles clockwise until you cannot turn them farther.
15.
If any of the PICs on the FPC connect to fiber-optic cable, remove the rubber safety
16.
cap from each transceiver and cable.
WARNING:
Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Chapter 19: Replacing T4000 Router Hardware Components
Do not bend or damage prongs
on power connector
247
Advertisement
Table of Contents
Troubleshooting
