Installing A T4000 Txp-Lcc-3D Sib; Figure 139: Removing A Txp-Lcc-3D Sib - Juniper T4000 Hardware Manual

Installing a T4000 TXP-LCC-3D SIB

Copyright © 2013, Juniper Networks, Inc.

Figure 139: Removing a TXP-LCC-3D SIB

To install a TXP-LCC-3D SIB:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Place one hand underneath the SIB to support it. With the other hand, hold one of the
2.
ejector handles on the SIB.
Carefully align the sides of the SIB with the guides inside the chassis.
3.
Slide the SIB into the chassis, carefully ensuring that it is correctly aligned
4.
(Figure 140 on page 287).
Grasp both ejector handles, and press them inward to seat the SIB. Ensure that the
5.
ejector handle tabs are properly mated inside their corresponding chassis slots. You
might have to close and open the handles a few times before the tabs catch the slots.
Tighten the captive screws on the ejector handles.
6.
Remove the dust covers from the transceivers and cables. Store the dust covers in a
7.
dust-free resealable plastic bag.
Insert the transceiver into the ports.
8.
CXP—Insert the CXP transceivers into the TXP-LCC-3D ports. The CXP transceivers
and the port are keyed to ensure proper mating. After all the CXP transceiver have
been installed, reconnect each CXP cable
transceiver in the TXP-LCC-3D port that corresponds to the label on the cable.
Chapter 19: Replacing T4000 Router Hardware Components
(Figure 141 on page 287) to the CXP
285