Installing A T4000 Pic; Figure 112: Removing A Pic - Juniper T4000 Hardware Manual

Installing a T4000 PIC

Copyright © 2013, Juniper Networks, Inc.

Figure 112: Removing a PIC

To install a PIC (see Figure 113 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
If the PIC uses fiber-optic cable, verify that there is a rubber safety cap over each
2.
transceiver on the faceplate. Install a cap if necessary.
Align the notches in the connector at the rear of the PIC with the notches in the PIC
3.
slot in the FPC, and then slide the PIC in until it lodges firmly in the FPC.
CAUTION: Slide the PIC straight into the slot to avoid damaging the
components on the bottom of the PIC.
Chapter 19: Replacing T4000 Router Hardware Components
257).
255