Replacing A T4000 Txp-Lcc-3D Sib; Figure 135: Installing A T4000 Sib - Juniper T4000 Hardware Manual

T4000 Router Hardware Guide
Related
Documentation

Replacing a T4000 TXP-LCC-3D SIB

282

Figure 135: Installing a T4000 SIB

T4000 Switch Interface Board (SIB) Description on page 46
T4000-SIB Description on page 46
Maintaining the T4000 SIBs on page 186
Troubleshooting the T4000 SIBs on page 209
Preventing T4000 Electrostatic Discharge Damage on page 296
Five SIBs are installed in the router. The SIBs are located in the rear of the chassis in the
slots marked through
SIB0
Each TXP-LCC-3D SIB weighs approximately 9.4 lb (4.2 kg). The TXP-LCC-3D SIBs are
connected to the TXP-F13-3D SIBs in a TX Matrix Plus router.
TXP-LCC-3D SIBs in active data switching planes are hot-pluggable. TXP-LCC-3D SIBs
in a spare data switching planes are hot-insertable and hot-removable. When you remove
a TXP-LCC-3D SIB in a spare switching plane, traffic forwarding continues without any
degradation as long as the other four switching planes remain online. However, removing
a TXP-LCC-3D SIB in an active switching plane might cause performance degradation
in that switching plane. To avoid performance degradation, you can take the switching
.
SIB4
Copyright © 2013, Juniper Networks, Inc.