T4000 Router Hardware Guide
Installing a T4000 Console or Auxiliary Cable
Related
Documentation
Replacing a T4000 Management Ethernet Cable
Removing a T4000 Management Ethernet Cable
226
The
AUXILIARY
port and
CONSOLE
serial cable with DB-9 connectors.
To connect a management console or auxiliary device:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the site ESD points on the chassis.
Connect one end of the replacement cable into the appropriate
2.
port. The ports labeled
Engine slot (
), and the ports labeled
RE0
lower Routing Engine slot (
Using a 2.5-mm flat-blade screwdriver, tighten the screws on the connector.
3.
Plug the other end of the cable into the device's serial port.
4.
T4000 Connector Interface Panel (CIP) Description on page 27
Connecting the T4000 Router to a Management Console or Auxiliary Device on page 112
T4000 Routing Engine Interface Cable Specifications on page 350
DB-9 Connector Pinouts for the Routing Engine AUXILIARY and CONSOLE Ports on
page 351
Removing a T4000 Management Ethernet Cable on page 226
1.
Installing a T4000 Management Ethernet Cable on page 227
2.
Press the tab on the connector, and pull the connector straight out of the
1.
port.
Figure 96 on page 226
Disconnect the cable from the network device.
2.
Figure 96: Ethernet Cable Connectors
port on the CIP both accept an RS-232 (EIA-232_
connect to the Routing Engine in the upper Routing
HOST 0
connect to the Routing Engine in the
HOST 1
RE1
).
shows the connector.
CONSOLE
or
AUXILIARY
ETHERNET
Copyright © 2013, Juniper Networks, Inc.