Juniper T4000 Hardware Manual page 175

Related
Documentation
Copyright © 2013, Juniper Networks, Inc.
NOTE: The default input current is 60-A.
(Optional) If the power has been underprovisioned for your configuration, some FPCs
3.
might not be brought online if the available power capacity is exceeded. When you
reboot the router, FPCs are brought online based on the default setting of the
fru-poweron-sequence
to change the default order in which FPCs are brought online when the router is
rebooted.
[edit]
user@host# set chassis fru-poweron-sequence fru-poweron-sequence
NOTE: The default is the numerical order of the FPC slots (0 through 7).
(Optional) Use the
4. show
correct.
[edit]
user@host# show
pem {
feeds 6;
input-current 40;
}
Commit the configuration to activate it on the router and exit configuration mode.
5.
[edit]
user@host# commit
user@host# exit
user@host>
T4000 Power System Description on page 43
Connecting DC Power to the T4000 Router (Five 60-A Inputs) on page 126
Connecting DC Power to the T4000 Router (Four 60-A Inputs) on page 130
Connecting DC Power to the T4000 Router (Three 80-A DC Power Cables to Six 60-A
Inputs) on page 133
Troubleshooting the T4000 Power System on page 204
T4000 DC Power Requirements on page 338
T4000 Power Management (Four 60-A Cables on a Six-Input DC Power Supply) on
page 340
T4000 Power Management (Three 80-A Cables on a Six-Input DC Power Supply) on
page 340
T4000 Power Management Overview
command. You can use the
statement to display the configuration to verify that it is
Chapter 14: Configuring Junos OS
command
fru-poweron-sequence
151