Verifying And Monitoring Bandwidth Distribution - Cisco 10000 Series Configuration Manual

Bandwidth Distribution Between Queues

Verifying and Monitoring Bandwidth Distribution

The Cisco 10000 series router collects statistical information about the current queue length, and the
number of packets and bytes transmitted and dropped (64 bits), which you can display using the show
commands in this section.
To verify and monitor bandwidth distribution in a policy map, enter the following commands in
privileged EXEC mode:
Command
Router# show policy-map interface
Router# show policy-map interface interface
[input | output]
Router# show policy-map policy-map-name
Router# show policy-map policy-map-name class
class-name
Cisco 10000 Series Router Quality of Service Configuration Guide
5-12
Chapter 5
Purpose
Displays the configuration of all classes configured for all policy
maps attached to all interfaces.
Displays the configuration of all classes configured for all inbound
or outbound policy maps attached to the specified interface.
interface is the name of the interface or subinterface whose policy
configuration you want to display.
input indicates to display the statistics for the attached inbound
policy.
output indicates to display the statistics for the attached outbound
policy.
If you do not specify input or output, the router displays
Note
information about all classes that are configured for all
inbound and outbound policies attached to the interface
you specified.
Displays the configuration of all classes contained in the policy
map you specify.
policy-map-name is the name of the policy map whose
configuration information you want to display. The name can be a
maximum of 40 characters.
If you do not specify a policy-map-name, the command displays
the configuration of all policy maps configured on the router.
Displays the configuration of the class you specify. The policy
map you specify includes this class.
policy-map-name is the name of the policy map that contains the
class configuration you want to display.
class-name is the name of the class whose configuration you want
to display. If you do not specify class-name, the router displays
class configuration for all classes in the policy map.
Distributing Bandwidth Between Queues
OL-7433-09