Policing Inbound Traffic At Two Levels Of Hierarchy - Cisco 10000 Series Configuration Manual

Chapter 13 Defining QoS for Multiple Policy Levels
Example 13-6
configured in
capacity of 64,000 kbps for the combined queues. The service-policy command applies the middle-level
policy named Southwest to the parent class-default class.
Example 13-6 Configuring a Top-Level Parent Policy of a Three-Level Hierarchy
Router(config-pmap)# policy-map Region1
Router(config-pmap)# class class-default
Router(config-pmap-c)# shape 64000
Router(config-pmap-c)# service-policy Southwest
Router(config-pmap-c)# exit
Router(config-pmap)# exit
Router(config)#

Policing Inbound Traffic at Two Levels of Hierarchy

To police the traffic the router accepts on an inbound interface with a service policy applied, enter the
following commands beginning in global configuration mode:
Use the following commands to configure both the child and parent policies. Configure the bottom-level
Note
child policy first and then the top-level parent policy. For information about additional actions you can
specify, see the
Command
Step 1
Router(config-pmap)# policy-map
policy-map-name
Step 2
Router(config-pmap)# class class-map-name
OL-7433-09
shows how to configure a top-level parent policy using the middle-level child policy
Example 13-5. In this top-level policy, the shape command indicates a total transmission
"Types of QoS Actions" section on page
Purpose
Creates or modifies a bottom-level child policy map.
policy-map-name is the name of the policy map. The name can be
a maximum of 40 alphanumeric characters.
Assigns the traffic class you specify to the policy map. Enters
policy-map class configuration mode.
class-map-name is the name of a previously configured class map
and is the traffic class for which you want to define QoS actions.
Cisco 10000 Series Router Quality of Service Configuration Guide
Configuring QoS for Multiple Queues
3-4.
13-19