Verification Examples For Traffic Policing - Cisco 10000 Series Configuration Manual

Quality of service configuration guide
Hide thumbs Also See for 10000 Series:
Table of Contents

Advertisement

Chapter 14
Simultaneous Policy Maps
Command
Router# show policy-map interface interface
Router# show policy-map session sid sid
Router# show pxf statistics qos policy-map
session sid sid
Router# show pxf statistics qos policy-map
interface interface
The router does not support displaying relationships between the two simultaneous policies.
Note

Verification Examples for Traffic Policing

This section provides the following verification examples. In the examples, the policy named parent1 is
applied on the interface and the policy named prec-only is applied on the virtual template or pushed from
RADIUS for the session.
OL-7433-09
Displaying Simultaneous Policy Map Information for Interfaces, page 14-20
Displaying Simultaneous Policy Map Information for PTA Virtual Interfaces, page 14-21
Displaying Simultaneous Policy Map Information for Virtual Access Interfaces, page 14-21
Displaying Simultaneous Policy Map Information for a LAC Session, page 14-22
Purpose
Displays statistical and configuration information about all of the
input and output policy maps attached to the interface you
specify.
To view the statistics for simultaneous policy maps, you
Note
must issue both the show policy-map interface
command and the show policy-map session sid
command.
Displays statistical and configuration information about the
policy map applied to the session you specify.
To view the statistics for simultaneous policy maps, you
Note
must issue both the show policy-map interface
command and the show policy-map session sid
command.
Displays the relationship of the two simultaneous policies and
statistical information applicable to the two policies. Displays the
policy map applied to the specified session (for example, the
session-owned policy) and the policy map applied to the interface
over which the sessions traverse (for example, the inherited
policy).
Displays the relationship of the two simultaneous policies and
statistical information applicable to the two policies. Displays
statistical information for the session and for the subinterface or
VC-level policy the session inherited. The information that
displays at the subinterface or VC level is the aggregate
information of all of the sessions using the subinterface or VC;
for example, the aggregate of the packets that were matched,
dropped, marked, queued, and so on.
Cisco 10000 Series Router Quality of Service Configuration Guide
Verification Examples for Traffic Policing
14-19

Advertisement

Table of Contents
loading

Table of Contents