Cisco 10000 Series Configuration Manual page 677

Chapter 18 Regulating and Shaping Subscriber Traffic
Command
Step 1
Router(config)# bba-group pppoe
group-name
Step 2
Router(config-bba-grp)# virtual-template
template-number
Step 3
Router(config-bba-grp)# exit
Step 4
Router(config)# interface atm
number.subinterface [point-to-point]
Step 5
Router(config-subif) pvc [name] vpi/vci
OL-7433-09
Purpose
Creates a PPP over Ethernet (PPPoE) profile. Enters BBA group
configuration mode.
group-name is the name of the PPPoE profile.
Associates a BBA group to the virtual template to be used for
cloning virtual access interfaces.
template-number is the identifying number of the virtual
template.
Exits BBA group configuration mode.
Creates or modifies a subinterface. Enters subinterface
configuration mode.
atm is the interface type.
number is the slot, module, and port number of the interface (for
example 1/0/0).
.subinterface is the number of the subinterface (for example,
1/0/0.1).
(Optional) point-to-point indicates that the subinterface connects
directly with another subinterface.
Creates or modifies an ATM permanent virtual circuit (PVC).
Enters ATM virtual circuit configuration mode.
(Optional) name identifies the PVC and can contain up to 15
characters.
vpi/ specifies the ATM network virtual path identifier (VPI) for
this PVC. You must specify the slash. Valid values are from 0 to
255. The router treats a value that is outside the range of valid
values as the connection ID. The default value is 0.
The arguments vpi and vci cannot both be set to 0; if one
Note
is 0, the other cannot be 0.
vci specifies the ATM network virtual channel identifier (VCI) for
this PVC. Valid values are from 0 to 1 less than the maximum
value set for this interface by the atm vc-per-vp command. A
value that is out of range causes an "unrecognized command"
error message.
The VCI value has local significance only and, therefore,
Note
is unique only on a single link, not throughout the ATM
network. Typically, lower values from 0 to 31 are reserved
for specific traffic (for example, F4 OAM, SVC signaling,
ILMI, and so on) and should not be used.
Cisco 10000 Series Router Quality of Service Configuration Guide
Queuing PPP Sessions on ATM VCs
18-37