Related Documentation - Cisco 10000 Series Configuration Manual

Related Documentation

Absolute priority
Class-map: VoD (match-any)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: ip precedence 3
Output queue: 0/64; 0/0 packets/bytes output, 0/0 drops
Bandwidth : 1500 kbps (Weight 73)
Class-map: class-default (match-any)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
Output queue: 0/32; 0/0 packets/bytes output, 0/0 drops
Related Documentation
This section provides hyperlinks to additional Cisco documentation for the features described in this
chapter. To display the documentation, click the document title or a section of the document highlighted
in blue. When appropriate, paths to applicable sections are listed below the documentation title.
Feature
BBA Groups
Frame Relay legacy commands
Subinterface Policy Maps
Virtual Access Interfaces
Virtual Template Interfaces
Cisco 10000 Series Router Quality of Service Configuration Guide
4-36
conformed 0 packets, 0 bytes; action: transmit
exceeded 0 packets, 0 bytes; action: drop
violated 0 packets, 0 bytes; action: drop
0 packets, 0 bytes
5 minute rate 0 bps
Related Documentation
Cisco 10000 Series Broadband Aggregation and Lease-Line Configuration
Guide
Cisco 10000 Series Router Quality of Service Configuration Guide
Cross-Platform Release Notes for Cisco IOS Release 12.0S
Cisco IOS Quality of Service Solutions Configuration Guide, Release 12.2
Cisco 10000 Series Broadband Aggregation and Lease-Line Configuration
Guide
Cisco 10000 Series Broadband Aggregation and Lease-Line Configuration
Guide
Cisco IOS Dial Technologies Configuration Guide, Release 12.2
Configuring PPPoE over Ethernet and IEEE 802.1Q VLAN
Configuring Frame Relay QoS Using Frame Relay Legacy Commands
Part 2: New Features and Important Notes > New and Changed
Information > New Software Features in Cisco IOS Release 12.0(22)S
> Subinterface Policy Maps
Part 8: Modular Quality of Service Command-Line Interface >
Configuring the Modular Quality of Service Command-Line Interface >
Modular QoS CLI Configuration Task List > Attaching a Traffic Policy
to an Interface
Configuring Remote Access to MPLS VPN
Configuring Remote Access to MPLS VPN
Configuring Virtual Template Interfaces
Chapter 4 Attaching Service Policies
OL-7433-09