Ppp Multilink Command - Cisco 10000 Series Configuration Manual

Link Fragmentation and Interleaving
•
•
For releases prior to Cisco IOS Release 12.2(28)SB, the valid multilink interface range is 1 to
2,147,483,647.

ppp multilink Command

To enable Multilink PPP (MLP) on an interface, use the ppp multilink command in interface
configuration mode. To disable MLP, use the no form of the command. By default, the command is
disabled.
ppp multilink
no ppp multilink
ppp multilink Command History
Cisco IOS Release
Release 12.0(23)SX
Release 12.2(16)BX
Release 12.2(28)SB
Release 12.2(31)SB2
Usage Guidelines for the ppp multilink Command
The ppp multilink command applies only to interfaces that use Point-to-Point Protocol (PPP)
encapsulation.
When you use the ppp multilink command, the first channel negotiates the appropriate Network Control
Protocol (NCP) layers (such as the IP Control Protocol and IPX Control Protocol), but subsequent links
negotiate only the Link Control Protocol (LCP) and MLP.
Cisco 10000 Series Router Quality of Service Configuration Guide
16-6
Multi-VC MLP over ATM-based LFI
1 to 9999 (Cisco IOS Release 12.2(28)SB and later releases)
–
1 to 9999 and 65,536 to 2,147,483,647 (Cisco IOS Release 12.2(31)SB2 and later releases)
–
MLP over Frame Relay-based LFI
10,000 and higher
–
Description
The ppp multilink command was introduced on the PRE1.
This command was introduced on the PRE2.
This command was integrated in Cisco IOS Release 12.2(28)SB for the
PRE2.
This command was introduced on the PRE3.
Chapter 16 Fragmenting and Interleaving Real-Time and Nonreal-Time Packets
OL-7433-09