Ppp Multilink Fragment Disable Command - Cisco 10000 Series Configuration Manual

Chapter 16 Fragmenting and Interleaving Real-Time and Nonreal-Time Packets

ppp multilink fragment disable Command

To disable packet fragmentation, use the ppp multilink fragment disable command in interface
configuration mode. To enable fragmentation, use the no form of this command.
ppp multilink fragment disable
no ppp multilink fragment disable
ppp multilink fragment disable Command History
Cisco IOS Release
Release 11.3
Release 12.2
Release 12.2(28)SB
Release 12.2(31)SB2
Usage Guidelines for the ppp multilink fragment disable Command
The ppp multilink fragment delay and ppp multilink interleave commands have precedence over the
ppp multilink fragment disable command. Therefore, the ppp multilink fragment disable command
has no effect if these commands are configured for a multilink interface and the following message
displays:
To completely disable fragmentation, you must do the following:
Router(config-if)# no ppp multilink fragment delay
Router(config-if)# no ppp multilink interleave
Router(config-if)# ppp multilink fragment disable
OL-7433-09
Description
This command was introduced as ppp multilink fragmentation.
The no ppp multilink fragmentation command was changed to
ppp multilink fragment disable. The no ppp multilink fragmentation
command was recognized and accepted through Cisco IOS Release 12.2.
This command was integrated in Cisco IOS Release 12.2(28)SB for the
PRE2.
This command was introduced on the PRE3.
Warning: 'ppp multilink fragment disable' or 'ppp multilink fragment maximum' will be
ignored, since multilink interleaving or fragment delay has been configured and have
higher precedence.
Cisco 10000 Series Router Quality of Service Configuration Guide
Link Fragmentation and Interleaving
16-9