Configuration Examples For Distribution Of Remaining Bandwidth Using Ratio - Cisco 10000 Series Configuration Manual

Distribution of Remaining Bandwidth Using Ratio
Command or Action
Step 11
service-policy child-policy-name
Step 12
exit
Step 13
exit
Step 14
interface type slot/module/port.subinterface
[point-to-point | multipoint]
Step 15
service-policy {input | output}
parent-policy-name

Configuration Examples for Distribution of Remaining Bandwidth Using Ratio

This section provides the following configuration examples:
•
•
•
•
Cisco 10000 Series Router Quality of Service Configuration Guide
5-20
Configuring Bandwidth-Remaining Ratios on Ethernet Subinterfaces: Example, page 5-21
Configuring Bandwidth-Remaining Ratios on ATM Subinterfaces: Example, page 5-21
Configuring Bandwidth-Remaining Ratios on Class Queues: Example, page 5-22
Verifying Bandwidth Remaining Ratios: Example, page 5-22
Chapter 5
Purpose
Applies the child policy map you specify to the traffic class.
The router applies the QoS actions specified in the child
policy to the traffic class.
child-policy-name is the name of the child policy.
The service-policy command typically requires that
Note
you specify the direction of the traffic using the
input or output keywords. However, when
applying a child policy to a parent policy, do not
specify traffic direction.
Exits policy-map class configuration mode.
Exits policy-map configuration mode.
Creates or modifies the interface you specify. Enters
subinterface configuration mode.
type is the interface type (for example, Gigabit Ethernet).
slot/module/port.subinterface is the number of the
subinterface that identifies the subinterface (for example,
1/0/0.1).
(Optional) point-to-point indicates that the subinterface is
a point-to-point subinterface.
(Optional) multipoint indicates that the subinterface is a
point-to-multipoint subinterface.
Applies the parent policy to the subinterface.
input indicates to apply the service policy to inbound
traffic.
output indicates to apply the service policy to outbound
traffic.
parent-policy-name is the name of the parent policy map.
When congestion occurs, the class queues receive
Note
bandwidth according to the specified class-level
bandwidth-remaining ratios.
Distributing Bandwidth Between Queues
OL-7433-09