Adding A Pvc To A Frame Relay Pvc Bundle - Cisco 10000 Series Configuration Manual

Chapter 19 Configuring Quality of Service for PVC Bundles
Command
Step 4
Router(config-if)# frame-relay map
protocol protocol-address {dlci |
vc-bundle vc-bundle-name} [broadcast]
[ietf] [cisco]
Step 5
Router(config-if)# frame-relay vc-bundle
vc-bundle-name
Configuration Example for Creating a Frame Relay PVC Bundle
Example 19-3
vermont.
Example 19-3 Creating a Frame Relay PVC Bundle
Router(config)# interface serial 0
Router(config-if)# encapsulation frame-relay
Router(config-if)# ip address 10.1.1.1
Router(config-if)# frame-relay vc-bundle vermont

Adding a PVC to a Frame Relay PVC Bundle

To add a PVC to a Frame Relay PVC bundle, enter the following commands beginning in global
configuration mode:
OL-7433-09
Purpose
(Optional) Maps between a next-hop protocol address and a data
link connection identifier (DLCI) destination address, and
creates a PVC bundle if it does not already exist.
protocol is ip or ipx.
protocol-address is the destination IP address.
dlci is the local DLCI number used to connect to the specified
protocol address on the interface. Valid values are from 16
through 1007.
vc-bundle vc-bundle-name is the name of a specific Frame Relay
PVC bundle configured on the interface.
(Optional) broadcast indicates to forward broadcasts to the
specified address when multicast is not enabled (see the
frame-relay multicast-dlci command for more information
about multicasts).
(Optional) ietf is the Internet Engineering Task Force (IETF)
form of Frame Relay encapsulation, based on RFC 1490 and
RFC 2427. Use the ietf keyword when the router is connected to
another vendor's equipment across a Frame Relay network.
(Optional) cisco is the Cisco-proprietary encapsulation method
consisting of a four-byte header, with two bytes to identify the
DLCI and two bytes to identify the packet type.
Note
Creates a PVC bundle if it does not already exist. Enters Frame
Relay VC bundle configuration mode.
vc-bundle-name is a name you assign to the Frame Relay PVC
bundle to identify the bundle.
shows how to create a Frame Relay PVC bundle. In the example, the PVC bundle is named
Cisco 10000 Series Router Quality of Service Configuration Guide
The frame-relay map command is required for
multipoint interfaces if Inverse ARP is disabled or is not
supported at the other end of the connection.
Frame Relay PVC Selection
19-43