Ppp Multilink Group Command - Cisco 10000 Series Configuration Manual

Link Fragmentation and Interleaving

ppp multilink group Command

To restrict a physical link to joining only a designated multilink group interface, use the ppp multilink
group command in interface configuration mode. To remove the restriction, use the no form of the
command. By default, this command is disabled.
ppp multilink group group-number
no ppp multilink group group-number
Syntax Description
group-number
ppp multilink group Command History
Cisco IOS Release
Release 12.0
Release 12.2
Release 12.2(28)SB
Release 12.2(31)SB2
Cisco 10000 Series Router Quality of Service Configuration Guide
16-10
Chapter 16 Fragmenting and Interleaving Real-Time and Nonreal-Time Packets
Identifies the multilink group. This number must be identical to the
multilink-bundle-number you assigned to the multilink interface. Valid
values are:
MLP over Serial-based LFI
•
1 to 9999 (Cisco IOS Release 12.2(28)SB and later releases)
–
1 to 9999 and 65,536 to 2,147,483,647 (Cisco IOS Release
–
12.2(31)SB2 and later releases)
Single-VC MLP over ATM-based LFI
•
10,000 and higher
–
Multi-VC MLP over ATM-based LFI
•
1 to 9999 (Cisco IOS Release 12.2(28)SB and later releases)
–
1 to 9999 and 65,536 to 2,147,483,647 (Cisco IOS Release
–
12.2(31)SB2 and later releases)
MLP over Frame Relay-based LFI
•
10,000 and higher
–
Description
The ppp multilink group command was introduced on the PRE1 as
multilink-group command.
The multilink-group command was changed on the PRE2 to ppp multilink
group. The multilink-group command was accepted by the command line
interpreter through Cisco IOS Release 12.2.
This command was integrated in Cisco IOS Release 12.2(28)SB for the
PRE2.
This command was introduced on the PRE3.
OL-7433-09