Verifying And Monitoring Wccp Configuration Settings; Wccp Configuration Examples - Cisco 7609 Configuration Manual

Chapter 35 Configuring Web Cache Services Using WCCP
To configure an MD5 password for use by the router in WCCP communications, perform this task in
global configuration mode:
Command
Router(config)# ip wccp web-cache password password

Verifying and Monitoring WCCP Configuration Settings

To verify and monitor the configuration settings for WCCP, use the following commands in EXEC mode:
Command
Router# show ip wccp [web-cache | service-number]
Router# show ip wccp {web-cache | service-number} detail
Router# show ip interface
Router# show ip wccp {web-cache | service-number} view

WCCP Configuration Examples

This section provides the following configuration examples:
•
•
•
•
•
•
78-14064-04
Changing the Version of WCCP on a Router Example, page 35-12
Performing a General WCCPv2 Configuration Example, page 35-12
Running a Web Cache Service Example, page 35-12
Running a Reverse Proxy Service Example, page 35-13
Registering a Router to a Multicast Address Example, page 35-13
Using Access Lists Example, page 35-13
Verifying and Monitoring WCCP Configuration Settings
Purpose
Sets an MD5 password on the router.
Purpose
Displays global information related to WCCP, including
the protocol version currently running, the number of
cache engines in the routers service group, which cache
engine group is allowed to connect to the router, and
which access list is being used.
Queries the router for information on which cache
engines of a specific service group the router has
detected. The information can be displayed for either
the web cache service or the specified dynamic service.
Displays status about whether any ip wccp redirection
commands are configured on an interface. For example,
"Web Cache Redirect is enabled / disabled."
Displays which devices in a particular service group
have been detected and which cache engines are having
trouble becoming visible to all other routers to which
the current router is connected. The view keyword
indicates a list of addresses of the service group. The
information can be displayed for either the web cache
service or the specified dynamic service. For further
troubleshooting information, use the show ip wccp
{web-cache | service number} service command.
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
35-11