Attaching Qos Service Policies To An Atm Pvc - Cisco 10000 Series Configuration Manual

Attaching ATM QoS Service Policies
Configuration Example for Attaching QoS Service Policies to an ATM Point-to-Point Subinterface
Example 4-2
for inbound traffic.
Example 4-2
Router(config)# interface atm 3/0/0
Router(config-if)# atm pxf queuing
Router(config-if)# interface atm 3/0/0.1 point-to-point
Router(config-subif)# service-policy input myQoS

Attaching QoS Service Policies to an ATM PVC

To attach a QoS service policy to an individual ATM PVC, enter the following commands beginning in
interface configuration mode:
Command
Step 1
Router(config)# interface atm
slot/module/port
Step 2
Router(config-if)# atm pxf queuing
Step 3
Router(config-if)# interface atm
slot/module/port.subinterface
point-to-point
Step 4
Router(config-subif)# pvc [name] vpi/vci
Cisco 10000 Series Router Quality of Service Configuration Guide
4-8
attaches a QoS service policy named myQoS to ATM point-to-point subinterface 3/0/0.1
Attaching a QoS Service Policy to an ATM Point-to-Point Subinterface
Purpose
Specifies the ATM interface and enters interface configuration
mode.
Specifies the interface mode. In this mode, the interface operates
in low VC count. The router operates in atm pxf queuing mode by
default. You do not need to specify this mode unless the router is
currently configured for no atm pxf queuing.
Note
Specifies the point-to-point subinterface and enters subinterface
configuration mode.
Creates an ATM permanent virtual circuit (PVC) and enters
ATM VC configuration mode.
name is the name used to identify the PVC.
vpi is the virtual path identifier.
vci is the virtual circuit identifier.
This is the required interface operating mode for QoS
service policies that include queuing actions.
Chapter 4 Attaching Service Policies
OL-7433-09