Qos Features, Commands, And Changes - Cisco 10000 Series Configuration Manual

Chapter 1 Quality of Service Overview
Or
interface GigabitEthernet1/0/0.1
encapsulation dot1q 1 second-dot1q any
service-policy output isp_A
Session-N-parent policy-maps attached to PPP/IP sessions via Radius or via
Virtual-Templates.

QoS Features, Commands, and Changes

This section describes the QoS features and commands supported on the Cisco 10000 series router, and
lists feature and command changes. It includes the following topics:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
OL-7433-09
Applying QoS Parameters Dynamically to Sessions, page 1-12
Applying Traffic Shaping Parameters Using RADIUS Profiles, page 1-12
Attaching QoS Service Policies, page 1-13
Classifying Traffic, page 1-15
Configuring QoS for MPLS Traffic, page 1-18
Control Plane Policing, page 1-19
Controlling Packet Queue Congestion, page 1-21
Distributing Bandwidth Between Queues, page 1-25
Dynamically Changing VC Weight and Watermark Values, page 1-26
Hierarchical Queuing Framework, page 1-27
Hierarchical Policies, page 1-27
IP Quality of Service for Subscribers, page 1-29
Layer 2 Access Concentrator, page 1-30
Link Fragmentation and Interleaving, page 1-31
Marking Traffic, page 1-36
Modular QoS Command Line Interface, page 1-39
Overhead Accounting, page 1-39
Oversubscribing Physical and Virtual Links, page 1-41
Policing Traffic, page 1-44
Prioritizing Traffic, page 1-48
PVC Bundles, page 1-50
QoS Policy Maps, page 1-53
Qos Policy Propagation through the Border Gateway Protocol, page 1-55
Shaping PPPoE Over VLAN Sessions Using RADIUS, page 1-55
Shaping Traffic, page 1-55
Sharing Bandwidth Fairly During Congestion, page 1-59
Simultaneous Policy Maps, page 1-60
Cisco 10000 Series Router Quality of Service Configuration Guide
QoS Features, Commands, and Changes
1-11