Bundle Command - Cisco 10000 Series Configuration Manual

ATM PVC Selection
bump Command History
Cisco IOS Release
Release 12.0(26)S
Defaults
Implicit bumping
Permit bumping (VCs accept bumped traffic)
Configuration Mode
VC-class configuration (for a VC class)
Bundle-vc configuration (for an ATM VC bundle member)
Usage Guidelines for the bump Command
If you configure implicit bumping, bumped traffic is sent to the PVC configured to handle the next lower
precedence level. When the original PVC that bumped the traffic comes back up, the traffic that it is
configured to carry is restored to it. If no other positive forms of the bump command are configured, the
bump implicit command takes effect.
If you configure a PVC with the bump explicit command, you can specify the precedence level or MPLS
EXP level to which traffic is bumped when that PVC goes down, and the traffic is directed to a PVC
mapped with that precedence or MPLS EXP level. If the PVC that picks up and carries the traffic goes
down, the traffic is subject to the bumping rules for that PVC. You can specify only one precedence level
for bumping.
The PVC accepts bumped traffic by default. If the PVC has been previously configured to reject bumped
traffic, you must use the bump traffic command to return the PVC to its default condition.
To configure a discrete PVC to reject bumped traffic when the traffic is directed to it, use the no bump
traffic command.

bundle Command

To create a bundle or modify an existing bundle, use the bundle command in subinterface configuration
mode. To remove the specified bundle, use the no form of the command. By default, no bundle is
specified.
bundle bundle-name
no bundle bundle-name
Syntax Description
bundle-name
Cisco 10000 Series Router Quality of Service Configuration Guide
19-6
Description
This command was introduced on the PRE1.
Specifies the name of the bundle to create or modify. The bundle-name is
limited to 16 alphanumeric characters.
Chapter 19 Configuring Quality of Service for PVC Bundles
OL-7433-09