Configuring Bandwidth Distribution Between Queues; Configuration Examples For Configuring Bandwidth Distribution - Cisco 10000 Series Configuration Manual

Bandwidth Distribution Between Queues

Configuring Bandwidth Distribution Between Queues

To configure or modify the amount of bandwidth allocated for a traffic class, enter the following
commands beginning in global configuration mode:
Command
Step 1
Router(config)# policy-map policy-map-name
Step 2
Router(config-pmap)# class class-map-name
Step 3
Router(config-pmap-c)# bandwidth
{bandwidth-kbps | percent percentage |
remaining percent percentage}
For information about classifying traffic and creating QoS service policies, see
Traffic"

Configuration Examples for Configuring Bandwidth Distribution

This section provides the following configuration examples:
•
•
•
Cisco 10000 Series Router Quality of Service Configuration Guide
5-10
and Chapter 3, "Configuring QoS Policy Actions and Rules."
Configuration Example for Kilobits per Second-Based Bandwidth, page 5-11
Configuration Example for Percentage-Based Bandwidth, page 5-11
Configuration Example for Bandwidth-Remaining-Based Bandwidth, page 5-11
Chapter 5
Purpose
Specifies the name of the policy map and enters policy-map
configuration mode.
policy-map-name is the name of the policy map.
Assigns the traffic class you specify to the policy map. Enters
policy-map class configuration mode.
class-map-name is the name of a previously configured class
map and is the traffic class for which you want to define QoS
actions.
Specifies or modifies the minimum bandwidth allocated for a
traffic class in a policy map.
bandwidth-kbps specifies or modifies the minimum
bandwidth allocated for a class belonging to a policy map.
Valid values are from 8 to 2,488,320, which represents from
1 to 99 percent of the link bandwidth.
Note The range of valid values for bandwidth-kbps might
be smaller than the values indicated above. Use the
question mark (?) in context-sensitive help to display
the range of valid values.
percent percentage specifies or modifies the minimum
percentage of the link bandwidth allocated for a class
belonging to a policy map. Valid values are from 1 to 99.
remaining percent percentage specifies or modifies the
minimum percentage of unused link bandwidth allocated for
a class belonging to a policy map. Valid values are from 1 to
99.
Note Configure the amount of bandwidth large enough to
also accommodate Layer 2 overhead.
Distributing Bandwidth Between Queues
Chapter 2, "Classifying
OL-7433-09