Configuring Ip Quality Of Service For Subscribers; Configuring Per Session Rate Limiting - Cisco 10000 Series Configuration Manual

Chapter 18 Regulating and Shaping Subscriber Traffic
Table 18-3 Output Policy Map Actions
Policy Map
Actions
set ip prec/dscp
set qos-group
set atm-clp
set cos
police
set mpls-exp

Configuring IP Quality of Service for Subscribers

To configure IP QoS for subscribers, perform the following configuration tasks:
•
•
•
If the policing action applies to all traffic through the interface, you can use the predefined class named
Note
class-default. Using one class in the policy map requires less process memory in the Cisco 10000 series
router.

Configuring per Session Rate Limiting

To configure per session rate limiting for PPPoA and PPPoE sessions, enter the following commands
beginning in global configuration mode:
Command
Step 1
Router(config)# class-map match [any |
all] class-map-name
Step 2
Router(config-cmap)# match parameters
Step 3
Router(config-cmap)# exit
Step 4
Router(config)# policy-map
policy-map-name
Step 5
Router(config-pmap)# class class-map-name
OL-7433-09
Normal
Valid
Not Applicable Not Applicable
Valid
Valid
Valid
Not Applicable Not Available
Configuring per Session Rate Limiting, page 18-9
Configuring per User Multiservice Rate Limiting, page 18-10
Configuring per Session Service Policy Using RADIUS, page 18-11
Interface Type
Tag (MPLS VPN)
Not Applicable
Not Available
Not Available
Valid
Purpose
Creates a class map with the name you specify and enters
class-map configuration mode.
class-map-name is the name of the class map.
Classifies traffic based on the parameters you specify.
parameters define the classification criteria for the class map.
Exits class-map configuration mode.
Creates a policy map with the name you specify and enters
policy-map configuration mode.
policy-map-name is the name of the policy map.
Specifies the class to which the policy map applies.
class-map-name is the name of a previously configured class
map. This is the name of the class map you specified in Step 1.
Cisco 10000 Series Router Quality of Service Configuration Guide
Subscriber-Based IP Quality of Service
Virtual Access ATM UBR VCs
Valid Valid
Not Applicable Not Applicable
Not Available Not Available
Valid Not Applicable
Valid Valid
Not Applicable Not Applicable
18-9