Cisco 10000 Series Configuration Manual page 12

Contents
Two-Rate Three-Color Marker for Traffic Policing
Percent-Based Policing
Control Plane Policing
AToM Set ATM CLP Bit Using a Policer
AToM Set FR DE as Police Action
Set Layer 2 CoS as a Policer Action
Set Inner CoS as a Policer Action
Set Inner and Outer CoS as a Policer Action
Dual Police Actions
Policing Support for GRE Tunnels
Interfaces Supporting Policing
Metering Traffic and Token Buckets
Committed Bursts and Excess Bursts
Data Included in the Policing Rate
Policing Rate Granularity
Avoiding Bandwidth Starvation Due to Priority Services
Restrictions and Limitations for Traffic Policing
Configuring Traffic Policing
Cisco 10000 Series Router Quality of Service Configuration Guide
xii
Feature History for the Two-Rate Color Marker
Configuration Commands for the Two-Rate Color Marker
police Command (Two-Rate)
6-11
Feature History for Percent-Based Policing
police percent Command
6-13
Feature History for Set ATM CLP Bit Marking As a Police Action
Feature History for AToM Set FR DE as Police Action
Feature History for Set Layer 2 CoS as Policer Action
Feature History for Set Inner CoS as a Policer Action
Feature History for Set Inner and Outer CoS as a Policer Action
6-16
Feature History for Dual Police Actions
Metering Traffic Using Token Buckets (Single-Rate Policer)
Metering Traffic Using Token Buckets (Two-Rate Policer)
Committed Bursts
6-21
Committed Burst Calculation
Excess Bursts
6-22
Excess Burst Calculation
Deciding if Packets Conform or Exceed the Committed Rate
6-25
Bandwidth and Policing
6-26
6-27
Configuring Single-Rate Traffic Policing Based on Bits per Second
6-8
6-9
6-9
6-11
6-11
6-13
6-14
6-14
6-15
6-15
6-15
6-15
6-16
6-17
6-17
6-17
6-18
6-21
6-22
6-22
6-23
6-25
6-26
6-9
6-14
6-16
6-18
6-19
6-23
6-28
OL-7433-09