Example Of Configuring And Applying An Hierarchical Policy Map - Cisco 10000 Series Configuration Manual

Queuing PPP Sessions on ATM VCs
interface ATM2/0/7.5555 point-to-point
!
interface Virtual-Template555

Example of Configuring and Applying an Hierarchical Policy Map

Example 18-13
example contains a child policy map named child1 with QoS features defined for the gold and bronze
traffic classes. The child1 policy is applied to the parent policy map, which is shaped to 512000 bps. The
hierarchical policy is applied to the virtual template named virtual-template 1.
Example 18-13 Configuring an Hierarchical Policy Map
Router(config)# policy-map child1
Router(config-pmap)# class gold
Router(config-pmap-c)# priority
Router(config-pmap-c)# police percent 40
Router(config-pmap-c)# class bronze
Router(config-pmap-c)# police 8000
Router(config-pmap-c)# exit
Router(config-pmap)# policy-map parent
Router(config-pmap)# class class-default
Router(config-pmap-c)# shape 512000
Router(config-pmap-c)# service-policy child1
Router(config-pmap-c)# exit
Router(config-pmap)# exit
Router(config)# interface virtual-template 1
Router(config-if)# service-policy output parent
Cisco 10000 Series Router Quality of Service Configuration Guide
18-40
class class-default
shape average percent 100
bandwidth remaining ratio 100
service-policy pm_hier_child_0_2
pvc 1/5555
vbr-nrt 4000 2000 50
no dbs enable
encapsulation aal5snap
protocol pppoe group pppoeoa-group
!
ip unnumbered Loopback5555
no logging event link-status
peer default ip address pool pool-1
ppp authentication chap
service-policy output pm_hier2_0_2
shows how to configure a hierarchical policy and apply it to a virtual template. The
Chapter 18 Regulating and Shaping Subscriber Traffic
OL-7433-09