Verifying The Dynamic Bandwidth Sharing Configuration - Cisco cBR 8 Configuration Manual

Verifying the Dynamic Bandwidth Sharing Configuration

Step 2
Step 3
Step 4
Verifying the Dynamic Bandwidth Sharing Configuration
Use the following commands to verify the dynamic bandwidth sharing information:
• show controllers Integrated-Cable slot/subslot/port bandwidth rf-channel—Displays the bandwidth
Cisco cBR Series Converged Broadband Routers Quality of Services Configuration Guide for Cisco IOS XE
Fuji 16.7.x
4
Command or Action
Example:
Router> enable
configure terminal
Example:
Router# configure terminal
interface integrated-cable
slot/subslot/portrf-channel
Example:
Router(config)# interface integrated-cable
1/0/0:0
cable rf-bandwidth-percent bw-percent
Example:
Router(config-if)# cable
rf-bandwidth-percent 50
information for RF channels.
Following is a sample output of the command:
Router# show controllers integrated-Cable 2/0/0 bandwidth rf-channel
Ctrlr RF IF
2/0/0 0 In2/0/0:0
Wi2/0/0:0
Wi2/0/0:1
2/0/0 1 In2/0/0:1
Wi2/0/0:0
Wi2/0/0:1
2/0/0 2 In2/0/0:2
Wi2/0/0:0
Wi2/0/0:1
2/0/0 3 In2/0/0:3
Wi2/0/0:0
Wi2/0/0:1
2/0/0 4 In2/0/0:4
Wi2/0/0:0
Wi2/0/0:1
2/0/0 5 In2/0/0:5
Wi2/0/0:0
Wi2/0/0:1
2/0/0 6 In2/0/0:6
Purpose
• Enter your password if prompted.
Enters global configuration mode.
Enters the cable interface mode.
Configures the bandwidth allocation for the
integrated cable interface.
CIR(Kbps) Guar(Kbps)
7500 13750
7500 13750
3750 10000
7500 13750
7500 13750
3750 10000
7500 12500
7500 12500
7500 12500
7500 12500
7500 12500
7500 12500
7500 12500
7500 12500
7500 12500
7500 12500
7500 12500
7500 12500
7500 12500
Dynamic Bandwidth Sharing