Cisco 10000 Series Configuration Manual page 114

Traffic Classification Using Class Maps
Command
Router(config-cmap)# match mpls experimental
mpls-exp-value
Router(config-cmap)# match mpls experimental
imposition value
Router(config-cmap)# match mpls experimental
topmost value
Router(config-cmap)# match qos-group number
Cisco 10000 Series Router Quality of Service Configuration Guide
2-8
Purpose
Specifies that the experimental (EXP) bit value of the packet must
match the MPLS EXP value that you specify.
mpls-exp-value specifies the value to which you want to set the
MPLS EXP bits. Valid values are from 0 to 7. You can specify up
to 8 MPLS EXP values.
This command is available only on the PRE1.
Note
Specifies that the experimental (EXP) bit value on the imposed
label entry of the packet must match the MPLS EXP value that you
specify.
value specifies the value to which you want to set the MPLS EXP
bits. Valid values are from 0 to 7. You can specify up to 8 MPLS
EXP values.
The match mpls experimental imposition command is
Note
available only on the PRE2.
Matches the experimental (EXP) value in the topmost label.
value specifies the value to which you want to set the MPLS EXP
bits in the topmost label header. Valid values are from 0 to 7.
The match mpls experimental topmost command is
Note
available only on the PRE2.
Specifies that the packet QoS group number value must match the
specified QoS group number.
number is a group number from 0 to 99.
Chapter 2 Classifying Traffic
OL-7433-09