Loading Pre-Drilled Stock Into The Ohcf For 2-Sided Print Jobs - Xerox Color 800 User Manual

Oversized High Capacity Feeder (OHCF)
3. Open the ream of paper with the seam side facing up.
4. Fan the sheets before loading them into the tray.
5. Load and register the paper against the right side of the tray as depicted below for
LEF direction:
6. Adjust the paper guides by pressing in the guide release and carefully moving the
Edge Guide until it lightly touches the edge of the material in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
7. If necessary, set the skew adjustment levers to the desired position for your print job.
8. Gently push in the tray until it comes to a stop.
If enabled by your System Administrator, the Paper Tray Properties screen may be
displayed on the UI.
9. From the Tray Properties window, enter the correct paper information, including size,
type, weight, and if necessary, paper curl and/or alignment option.
10. Select OK to save the information and close the Tray Properties window.

Loading pre-drilled stock into the OHCF for 2-sided print jobs

1. Select the appropriate paper stock for your print job.
2. Pull out the tray slowly until it stops.
3. Open the ream of paper with the seam side facing up.
4. Fan the sheets before loading them into the tray.
5. Load and register the paper against the right side of the tray as depicted below for
LEF direction:
13-6 ®
Xerox Color 800/1000 Press
User Guide