Maintenance; Cleaning Procedures; Cleaning The Ui Screen; Cleaning The Paper Path - Xerox Color 800 User Manual

Maintenance

Cleaning procedures

If the exterior surfaces require cleaning, dampen a paper towel or a soft, clean cloth
with a liquid, nonabrasive glass cleaner or water.
Caution
Do not use any other cleaners or solvents on the machine as they may interact with the
paint on the covers, eventually causing the paint to peel.
Caution
Do not pour or spray liquid directly into any of the paper trays. Always apply the liquid
to the cloth first.

Cleaning the UI screen

Clean the UI screen at the start of each day. Remove all dust and fingerprints by wiping
the screen with a clean, lint-free cloth.
Caution
To avoid damage, do not use any Xerox cleaner, water, or commercial cleaner on the
screen.

Cleaning the paper path

Note
It is recommended that you perform the following procedures on a daily basis, preferably
at the start of the day before the machine is switched on and the fuser is cool. Only
clean the recommended areas of the paper path as described in these procedures.
Warning
If the machine is switched on and the fuser is hot, be sure to switch off the machine
power and allow 30 minutes for the fuser to cool before performing this procedure.
®
Xerox Color 800/1000 Press
User Guide
9
9-1