Fault Codes - Xerox Color 800 User Manual

SquareFold Trimmer Module

Fault codes

If a jam/fault occurs in the SquareFold Trimmer Module, the machine's UI displays a
jam/fault message. The following table provides a list of fault codes for the SquareFold
Trimmer Module and a list of related finisher fault codes.
Note
The top covers cannot be opened during normal operation or when the machine is idle.
The covers can be opened only when an indicator is lit and a jam/fault occurs within the
SquareFold Trimmer Module. For indicator details, refer to the control panel information
earlier in this section.
Fault Possible cause
code
013-100 Jam/fault with the SquareFold
Trimmer Module
013-101
013-102
013-103
013-104
013-105
013-106
013-303
013-915
013-916
013-917
013-918
013-919
18-16
Recommended solution
1. Open the Top Left and Right Covers of the
SquareFold Trimmer Module.
2. Carefully remove all sheets and paper
scraps from jam clearance areas.
3. Close the SquareFold Trimmer Module Top
Left and Right Covers.
4. Check the Trimmer Waste Container:
• If full, empty the container and reinsert
it into the SquareFold Trimmer Module.
If the container is partially pulled out,
•
push it completely in.
5. If necessary, follow any remaining
instructions on the machine's UI.
6. If fault persists, repeat Steps 1-5; if fault
persists after that, call for service.
Xerox
®
Color 800/1000 Press
User Guide