Print Jobs; Loading Pre-Drilled Stock Into The Ohcf (1 Or 2 Trays) For 1-Sided Print Jobs - Xerox D95 User Manual

Oversized High Capacity Feeder (OHCF), 1 or 2 trays (Trays 6/7)
5. Adjust the paper guides by pressing in the guide release and carefully moving the
Edge Guide until it lightly touches the edge of the material in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
6. If necessary, set the skew adjustment levers to the desired position for your print job.
7. Gently push in the tray until it comes to a stop.
If enabled by your System Administrator, the Paper Tray settings screen may be
displayed on the UI.
8. If changes have been made to the paper tray, select the Change Settings button;
otherwise proceed to the next step.
a) Make the desired selections for the Paper Type/Paper Weight, Paper Size, and
Paper Color.
b) If necessary make the desired changes to the paper curl and alignment adjustment.
Note
Refer to the System Administration for detailed information on the paper curl and
alignment adjustment options.
c) Select Save until you are returned to the tray settings window.
9. Select Confirm to close the window.
Loading pre-drilled stock into the OHCF (1 or 2 Trays) for 1-sided

print jobs

1. Select the appropriate paper stock for your print job.
2. Pull out the tray slowly until it stops.
3. Open the ream of paper with the seam side facing up.
4. Fan the sheets before loading them into the tray.
18-6 ®
Xerox D95/D110/D125 Copier/Printer
User Guide