Standard Finisher Plus Fault Codes; Finisher Module Fault Codes - Xerox Color 800 User Manual

6. Reinstall the cartridge unit to its original position in the finisher.
7. Close the Right Cover on the finisher.
Note
A message will display and the machine will not operate if the right cover is open
even slightly.

Standard Finisher Plus fault codes

Finisher Module fault codes

If an error code appears that is not listed in the table below, or if an error persists after
following the listed solution, then contact your Xerox Customer Support Center.
Fault code
013 108
013 109
013 110
013 910
013 911
®
Xerox Color 800/1000 Press
User Guide
Possible cause
The transport in sensor in
the Finishing Transport did
not switch ON within a
specified amount of time.
The transport exit sensor
in the Finishing Transport
did not switch ON within a
specified amount of time.
The transport exit sensor
in the Finishing Transport
did not switch OFF within
a specified amount of
time.
Paper jam at the transport
in sensor (Finishing
Transport)
Paper jam at the transport
exit sensor (Finishing
Transport)
Standard Finisher Plus
Recommended solution
• Check for any obstructions or
paper jams in the Finishing
Module and Finishing Transport
paper paths and clear them.
• If necessary, power Off/On the
machine, and if necessary,
resend/restart your print job.
• If the fault persists, contact the
Customer Support Center.
19-39