Second (2Nd) Bias Transfer Roll - Xerox Color 800 User Manual

Examples:
• Some coated, heavier paper types slip and skew, thereby misregistering the image
on the output prints. In this case, you may want to increase the roll pressure in order
to compensate for the slippage and skewing.
• Some light-weight papers may have too much roll pressure applied to them, thereby
causing edge damage to the output prints. In this case, you may to decrease the roll
pressure.
Tip
Increasing the roll pressure for some faults, may allow you to postpone a service call.
However, you may want to call your service representative as soon as possible in order
to restore the machine to its full feeding capabilities.
Note
The default setting is 0. It is recommended that you leave this option at its default
setting until you run test prints and evaluate the output of the prints.
Important
Changing the default setting should be considered a temporary solution because
environmental conditions vary from day to day. It is recommended that upon completion
of the print job, you return the option to its default setting.

Second (2nd) bias transfer roll

The second bias transfer roll is where the image is transferred from the belt to the paper.
The 2nd Bias Transfer Roll (2nd BTR) option is normally used with special stocks like
heavier weight paper, such as 220 gsm and greater, 10 pt, or 12 pt. However there are
times when it is also used with lighter weight paper as well. When using either heavier
or lighter weight paper, you may want or need to adjust Side 1 for all 1-sided jobs.
®
Xerox Color 800/1000 Press
User Guide
Advanced Stock Setup
8-9