Version of the Controller
To use all the functions of the monitor, the controller
(BKM-16R) with software version 1.7 or higher is
Certain functions of the monitor cannot be controlled if the
controller with a lower version is used.
Installing an Input
Loosen two screws and remove the cover of an input
option port on the side panel of the monitor.
Cover of an input
Make sure the MAIN
POWER switch is turned
off, and disconnect the AC
Insert the adaptor facing the board as shown below.
Push the adaptor in until it is firmly fit into the
connector inside the monitor, then tighten the two
screws to secure the adaptor.
Version of the Controller / Installing an Input Adaptor (BVM-F250A)