[H] Setting The Controller - Controller Menu; Overview; Structure Of The Controller Menu; Setting Lists In The Controller Menu - Sony TRINITRON BVM-A20F1U Operation Manual

[H] Setting the Controller
– CONTROLLER Menu

Overview

This menu is for the network setting of the controller.
• Setting the display method of the monitor select
display window (MONITOR ID DISPLAY menu)
• Settings for IP address, subnet mask and default
gateway of the controller (NETWORK SETTINGS...
menu)
• Displaying the setting of the NETWORK switch
(NETWORK SW menu)

Structure of the CONTROLLER Menu

Level 1 Level 2
MONITOR ID
DISPLAY [H1]
NETWORK IP ADDRESS
SETTINGS... [H2]
SUBNET MASK
DEFAULT GATEWAY
ADDRESS
NETWORK SW
SNMP CONTACT
SETTINGS... [H3]
NAME
LOCATION
TRAP
Setting Lists in the CONTROLLER
Menu
This section explains the setting lists displayed in the
menu.
How to read the setting lists
• For purposes of explanation, each setting list is preceded
by a menu number. These numbers are not displayed on
the screen.
For more information on the menu number, see "About
menu numbers" on page 26.
• The arrow mark (k) refers you to another setting list
that appears after you make the setting, or to an operation
that is to be carried out as a result of the setting.
54
[H] Setting the Controller – CONTROLLER Menu
[H] CONTROLLER menu
The network, system, etc. of the controller is set.
[H1] MONITOR ID DISPLAY menu
When the NETWORK switch is set to LAN, the display
method of the monitor select display window is set.
As the NETWORK switch is not equipped with BVM-
A14F5U/A14F5M/A14F5A and the function is set to LAN
Level 3
mode, when BVM-A14F5U/A14F5M/A14F5A is used as
the controller, this is always selectable.
[H2] NETWORK SETTINGS... menu
Set the IP address, subnet mask and default gateway.
Note
When the NETWORK switch is set to PEER TO PEER, the
IP address is set to "192.168.000.100" regardless of the
display.
When the NETWORK switch is set to LAN, the IP address
is set to the displayed one.
[H3] SNMP SETTINGS... menu
MONITOR ID DISPLAY: When the NETWORK
switch is set to LAN, set the display method of the
monitor select display window. k[H1]
NETWORK SETTINGS...: Display the NETWORK
SETTINGS menu. k[H2]
NETWORK SW: Display the setting of the
NETWORK switch (LAN or PEER TO PEER).
As the NETWORK switch is not equipped with
BVM-A14F5U/A14F5M/A14F5A and the
function is set to LAN mode, when BVM-A14F5U/
A14F5M/A14F5A is used as the controller, this is
not displayed.
SNMP SETTINGS...: Set CONTACT, NAME,
LOCATION and TRAP. k[H3]
ON: Always displayed (default).
AUTO: Displayed during operating by the remote
connection and cleared after operation
OFF: Not displayed.
IP ADDRESS: Set the IP address (default setting is
"192.168.000.100").
SUBNET MASK: Set the subnet mask (default setting
is "255.255.255.0").
DEFAULT GATEWAY: Set the default gateway on
or off (default setting is OFF).
ADDRESS: Set the default gateway (default
setting is "---.---.---.--- (no setting)").
CANCEL: Select to cancel the setting.
CONFIRM: Select to save the setting.
CONTACT menu: Set the information of the
administrator.
NEW NAME: Enter a new name (up to 20
characters).