Table of Contents
Advertisement
Menu
Service 708
Service 608
OSD Level
Audio Level Meter
Audio CH
Position
Transparency
Peak Hold
Time Code
VITC/LTC
Position
Level
Over Range
Password
Change Password
Function and operation ([
Sets Service when Type is set to 708.
You can select from Service1 to Service6. [Service1]
Sets Service when Type is set to 608 (VBI) or 608 (708).
You can select from CC1 to CC4 or Text1 to Text4. [CC1]
Sets the luminance of the letter.
You can select from High (bright), or [Low] (dark).
Sets the audio level meter.
When the BKM-250TG is installed, you can select the item.
The setting is effective for the input signal of the BKM-250TG.
Note
As the audio level meter is superimposed on the video signal, the audio level meter may be
cut partially because of the scan mode setting of the monitor.
Sets the audio channel.
You can select from [CH1-CH8] or CH9-CH16.
Sets the display position of the audio level meter.
You can select from [Bottom] (bottom) or Top (top).
Sets the transparency of the background of the audio level meter.
You can select from Black (black) or [Half] (translucence).
Sets the peak hold mode of the audio level meter.
[Off]: The peak hold does not function.
Auto: The peak hold is automatically released after about 1 second.
Manual Reset: The peak hold is released manually.
To release the peak hold, select ALM Hold Reset (page 70) in the Function Switch menu
of the Function Setting menu or set ALM Hold Reset to on by pressing the ALM Hold
1)
Reset button
of the controller.
1)ALM Hold Reset is assigned to the controller in the Function Key menu (page 83) of the Controller
menu.
Sets the time code.
The setting is effective when the SDI signal is input.
Note
As the time code is superimposed on the video signal, the time code may be cut partially
because of the scan mode setting of the monitor.
Sets the type of the time code.
You can select from [VITC] or LTC.
Sets the display position of the time code.
You can select from Top Left (top left), [Top Center] (top center), Top Right (top right),
Bottom Left (bottom left), Bottom Center (bottom center) or Bottom Right (bottom right).
Sets the luminance of the time code.
You can select High (bright) or [Low] (dark).
When a portion of the signal exceeds the dynamic range of the internal signal processing
circuit, it is determined as Over Range. This menu sets whether or not to display a zebra
pattern on the detected Over Range portion ([Off], On).
When Over Range is detected, adjust the contrast or brightness to a lower level.
Note
When Over Range occurs, the OVER RANGE lamp on the front of the unit lights in amber
regardless of the setting of this menu.
Sets the password for the menu.
Enter a four-digit number for the password. [9999]
Changes the password.
Enter New Password: Enter a new password with the numeric buttons and press the
ENTER (Ent) button.
Re-Enter Password: Enter the new password again and press the ENTER (Ent) button.
The password is registered.
To change it, press the MENU button.
]: factory setting)
75
System Configuration Menu
Advertisement
Table of Contents
