Setting For The Lan To Connect The Multiple Units - Sony BVMF170A Operation Manual

3
Confirm the settings.
Select Area
XXXXXXXXXX
Color Temp: xx
Setup Level: xx
Component Level: xx
Color Profile: xx
Cancel
Confirm
Cancel: Select to cancel the setting and return to the
Select Area screen.
Confirm: Select to save the setting and end selecting
the area.
See "Default value for each area" on page 33 on the
setting value.
After saving and reflecting the setting, you can change the
setting with the menu.
• Color Temp (color temperature) (page 58)
• Setup Level (NTSC Setup Level: page 60, Betacam
Setup Level: page 60)
• Component Level (page 60)
• Color Profile (page 58)
Setting for the LAN to Connect the
Multiple Units
You can control the multiple monitors using the controller
(BKM-16R, optional) connected via each LAN (10/100)
connector. You can also control a specific monitor or
monitor group.
Set an IP address to the monitors and the controller and a
monitor ID number and group ID number to each monitor.
1
Set the NETWORK switches of each monitor and the
controller to PEER TO PEER.
BVM-F250A
NETWORK switch
t Set to PEER TO
PEER.
Controller
(BKM-16R)
NETWORK switch
tSet to PEER TO PEER.
BVM-F170A
Controller
NETWORK switch
(BKM-16R)
tSet to PEER TO PEER.
2
Set the different IP address to each monitor and the
controller.
Monitor: Set the IP address in the Network Setting
menu (page 72) of the System Configuration menu.
Controller: Set the IP address in the Network Setting
menu (page 82) of the Controller menu.
3
Set Monitor ID and Group ID in the Network menu
(page 72) of the System Configuration menu.
Set the different monitor ID number to each monitor
and if necessary, group ID number.
You can use the numbers 1 to 99 as a monitor ID
number or group ID number.
4
Set the NETWORK switches of the monitor and the
controller to LAN.
NETWORK switch
t Set to PEER TO PEER.
Settings
35