1 MAIN POWER switch
2 DC IN 24 V - 28 V
3 AC IN connector
a MAIN POWER switch
When turned on, the monitor enters operation mode. By
setting in the Power menu (page 74) of the System
Configuration menu, the monitor can also be set to enter
standby mode when the MAIN POWER switch is turned
b DC IN 24 V - 28 V (DC power input) connector
(XLR 3-pin, male)
Connect the 24 V to 28 V DC power supply.
+ (24 V to 28 V DC)
c AC IN connector (3-pin)
Connects the monitor to an AC power source, via the
supplied AC power cord.
d DC 5V OUT connector (female)
Supplies the DC power to the controller.
Connect to the DC 5V/12V IN connector of the controller
with the SMF-700 or the cable supplied with the BKM-
DC 5V OUT connector (female) is non LPS (Limited
Power Source) circuit.
Location and Function of Parts (BVM-F170A)
e LAN (10/100) connector (10BASE-T/100BASE-TX)
Connect to the LAN (10/100) connector of the controller
by using the SMF-700 or the cable supplied with the BKM-
39H. Or connect to the network or the LAN (10/100)
connector of the controller by using a 10BASE-T/
100BASE-TX LAN cable (shielded-type, optional).
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
• When you connect the LAN cable of the unit to
peripheral device, use a shielded-type cable to prevent
malfunction due to radiation noise.
• The connection speed may be affected by the network
f NETWORK switch
LAN: To connect to the network.
PEER TO PEER: To connect to the LAN (10/100)
connector of the controller in 1 to 1 connection.
g PARALLEL REMOTE connector (D-sub 9-pin,
Forms a parallel switch and controls the monitor
externally. The pin assignment and factory setting
function assigned to each pin are given below.
4 DC 5V OUT connector
5 LAN (10/100) connector
6 NETWORK switch
7 PARALLEL REMOTE
8 STANDARD PORT
9 HDMI IN connector
q; DisplayPort input connector
qa Input option ports