Attaching The Handle (Bvm-E171); Connecting The Controller (Bkm-17R) - Sony BVM-E251 Operating Instructions Manual

Attaching the Handle
(BVM-E171)
1
Remove the 2 screws on the top side.
Note
Keep the removed screws in a safe place to prevent
them from being lost.
2
Attach the handle with the supplied screws.
Screws (supplied)
Notes
 Make sure that the screw clamp is not loosened.
 Secure the handle attachment.
16
Attaching the Handle (BVM-E171) / Connecting the Controller (BKM-17R)
Connecting the Controller
(BKM-17R)
Note
When you connect the BKM-16R, refer to the operating
instructions of BKM-16R.
Controller
(BKM-17R)
Handle
(supplied)
1
2
3
4
NETWORK switch:
Set to PEER TO PEER.
LAN (10/100)
connector
SMF-17R20, etc.
LAN (10/100)
connector
NETWORK switch:
Set to PEER TO PEER.
Turn off the power switch of the monitor before
connecting the units.
Set the NETWORK switches of the monitor and the
controller to PEER TO PEER.
Connect the LAN (10/100) connector of the
monitor and the LAN (10/100) connector of the
controller by using the SMF-17R20 or the cable
supplied with the BKM-37H/38H/39H, or a
10BASE-T/100BASE-TX straight LAN cable
(shielded-type, sold separately).
Connect the DC 12V OUT connector of the
monitor and DC 12V connector of the controller by
using the SMF-17R20 or the cable supplied with the
DC 12V OUT
connector
DC 12V connector