• When an optional LAN cable is connected, use a
shielded-type cable to prevent a malfunction due to
• We recommend to use an optional switching hub
with auto selection function (AUTO MDI/MDI-X)
of a straight/cross cable.
Connect the output cable on the AC adaptor supplied
with controller to the DC 5V/12V IN connector of the
When the multiple units are connected, set for the LAN
before setting the NETWORK switch to LAN (page
Set the NETWORK switches of each monitor and the
controller to LAN.
Turning on the Power
Connecting the AC Power Cord
Plug the AC power cord into the AC IN connector on
the left side panel. Then, attach the AC plug holder
(supplied) to the AC power cord.
AC power cord (supplied)
Attach the AC plug holder to the AC power cord, and connect
the cord to the AC IN connector so that the cord does not come
Slide the AC plug holder over the cord until it locks.
To disconnect the AC power cord
Pull out the AC plug holder while pressing the lock levers.
Turning on the Monitor
Press the MAIN POWER switch on the left side panel to
turn on the power.
When you turn on the monitor for the first time after
purchasing it, the Select Area screen is displayed. Select
the area where you intend to use this monitor.
For selecting the area, see page 33.
AC plug holder (supplied)
Turning on the Power (BVM-F250A)