Table of Contents
Advertisement
Menu
HDMI
DisplayPort
HDMI/DisplayPort Auto
1080I/PsF
24PsF
25PsF/50I
30PsF/60I
Copy From
Other CH
Other Monitor
Monitor ID
Memory Stick
Function and operation ([
Sets the display mode for the HDMI signal.
Full: 0 (black) to 255 (8bit)/1023 (10bit)/4095 (12bit) (white level)
[Limit]: 16 (8bit)/64 (10bit)/256 (12bit) (black level) to 235 (8bit)/940 (10bit)/3760 (12bit)
(white level)
Sets the display mode for the DisplayPort signal.
[Full]: 0 (black level) to 63 (6bit)/255 (8bit)/1023 (10bit)/4095 (12bit) (white level)
Limit: 4 (6bit)/16 (8bit)/64 (10bit)/256 (12bit) (black level) to 58 (6bit)/235(8bit)/940
(10bit)/3760 (12bit) (white level)
Sets the manual or automatic setting for the quantization range of the HDMI or DisplayPort
signal.
Off: Select to use the quantization range set in the HDMI or DisplayPort menu.
[On]: Select to set the quantization range automatically according to the input signal.
When the 1080i/PsF signal is input, select the display mode.
You can select when Format is set to 3G/HD/SD-SDI Auto, HD/SD-SDI Auto, 4:2:2 YCbCr
10bit, 4:4:4 YCbCr 10bit, 4:4:4 RGB 10bit, 4:4:4 YCbCr 12bit, 4:4:4 RGB 12bit, Component
YPbPr or Component RGB.
When 1080I is selected, the I/P conversion signal is displayed. When 1080PsF is selected,
the progressive conversion (PsF to P) signal is displayed.
When the 1080PsF signal is input and 1080I is selected, the display delay is shortened. The
signal converted from PsF to P is not displayed and the I/P conversion signal is displayed.
When Format is set to 3G/HD/SD-SDI Auto and Payload ID data are superimposed on the
SDI signal, 1080i/PsF processing is performed based on the Payload ID data, regardless of
the setting value.
Sets the display mode for the 1080/24PsF signal.
You can select from 1080I or [1080PsF].
Sets the display mode for the 1080/25PsF, 50i signal.
You can select from [1080I] or 1080PsF.
Sets the display mode for the 1080/30PsF, 60i signal.
You can select from [1080I] or 1080PsF.
Copies signal setting data from other channel.
Note
Use the controller with software version 1.6 or higher to use the Copy From function.
Copies other data in this monitor.
When the item is selected, you can designate the channel to be copied.
Copies data from other monitor.
Enters the ID number of the source monitor.
When the NETWORK switch is set to PEER TO PEER, this is not selectable.
When the item is selected, you can designate the source monitor.
When the ID number is entered, you can designate the channel to be copied.
Copies data in the "Memory Stick".
When the item is selected, the file names in the source "Memory Stick" are displayed.
When the file is selected, you can enter the channel number in the selected file.
]: factory setting)
61
Channel Configuration Menu
Advertisement
Table of Contents
